Installing/Replacing Batteries; Temperature/Flood Sensor (Not Evaluated By Ul) - AT&T Digital Life Installation And Operation Manual

Specifications—RPT4 RF Receiver
Receiver Type
Receiver Frequency
Receiver Output
Specifications—RPT4 RF Transmitter
Transmitter Type
Transmitter Frequency
Transmitter Range
Transmitter Output
Transmitter Reports
6.2.10.9

Installing/Replacing Batteries

The repeater has two non-rechargeable CR123 batteries as a backup power supply. The
batteries can be replaced by opening the battery compartment located on the rear of the
unit.

6.2.11 Temperature/Flood Sensor (Not Evaluated by UL)

The AT&T model number SW-ATT-TF Sensor is a fully supervised, tamper protected
sensor that will monitor either the ambient temperature or will detect a flood/no flood
condition. The sensor reports temperature and flood/no floods conditions to the DLC.
You can configure the sensor in one of three ways:
Detect temperature only
Detect flood/no flood only
Detect temperature and flood/no flood conditions.
Installation and Operations Manual
Crystal controlled
433.92MHz
Internal Antenna in Digital Life Controller Cabinet
Crystal controlled
433.92MHz
500 feet minimum with REC receiver unit.
Eight transmissions with a random delay of 50 -
360ms between packets (anti-clashing)
Status (transmitter condition)
Low Battery
Low Battery Restore
AC Power Source
DC Power Source
AT&T Proprietary (Internal Use Only)
—115—