6.2.6 Glass Break Detector
The AT&T model number SW-ATT-GB Glass Break Detector is a fully supervised,
tamper protected ceiling- or wall-mounted unit with a 15-foot maximum detection range,
360° maximum horizontal sensing angle, and dual-stage glass break detection, as
shown in Figure 55.
6.2.6.1 Discovering and Registering the Glass Break Detector
Follow these steps to discover and register the glass break detector:
Step
1.
Place the DLC into Discovery Mode in DLD.
2.
Make the glass break detector discoverable by inserting the two batteries.
Alternate Method: Press and hold the tamper switch for at least two (2)
seconds then release the switch.
3.
Confirm that the glass break detector has been discovered in DLD.
4.
Label the glass break detector in DLD.
Figure 55: Glass Break Detector
Action
AT&T Proprietary (Internal Use Only)
Installation and Operations Manual
—88—