Assembling The Dlc Antennas; Figure 35: Installing Antennas-Dlc Cabinet - AT&T Digital Life Installation And Operation Manual

5.3.3 Assembling the DLC Antennas

Assemble the DLC cabinet by installing the four external antennas, as shown in Figure
35.
Follow these steps to install the antennas:
Step
1. Locate the 3G antenna and screw into the designated port on the side of the
cabinet. The 3G antenna is wired to the 3G module.
2. Locate the two 433MHz antennas and screw into the designated ports.
3. Locate the 915MHz antenna and screw into the designated port.
4. Tighten each antenna until it is hand-tight.
Figure 35: Installing Antennas—DLC Cabinet
Action
AT&T Proprietary (Internal Use Only)
Installation and Operations Manual
—51—