Figure 91: Keypad - Example: Arming Exit Now; Figure 92: Keypad - Bypass In Ready To Arm State - AT&T Digital Life Installation And Operation Manual

Installation and Operations Manual
To proceed with arming the system, either close the open sensor(s) or press the
BYPASS key to bypass the sensor(s). The system will proceed with the Arming
STAY/AWAY sequence, as shown in Figure 91.
Figure 91: Keypad – Example: Arming Exit Now
You should exit through the designated entry/exit door(s) before the exit delay time
period expires. After the exit delay time period expires, the system is in the Armed-STAY
or Armed-AWAY mode. The ARMED (Red) LED is illuminated and the LCD displays
"Armed - STAY" or "Armed –AWAY".
NOTE: You may disarm the system during the exit delay time period by entering the four
(4) digit Security Code.
If the system is in the "Not Ready to Arm" state and the BYPASS button is pressed prior
to pressing the STAY or AWAY button, the LCD displays the following message "Press
STAY or AWAY," as shown in Figure 92.
Figure 92: Keypad – BYPASS in Ready to Arm State
AT&T Proprietary (Internal Use Only)
—133—