Installing The Transmitter; Figure 53: Installing Recessed Dw Sensor - AT&T Digital Life Installation And Operation Manual

CAUTION: Many windows may not accept the magnet which is
approximately 5/8 of an inch deep. Be sure to measure and determine
whether the window can accept the SW-ATT-RDW. If not, use the SW-ATT-
V2.
CAUTION: Do not use the SW-ATT-RDW if the door or window jams are
made of metal. The metal will severely limit the performance of the
transmitter portion of the device.

6.2.5.3 Installing the Transmitter

The hardware kit for the RDW sensor provides additional plastic parts for securing the
transmitter to the door jam, as shown in Figure 53.
Follow these steps to install the RDW Sensor:
Step Action
1. Locate the position where the transmitter section will be located on the door or
window jam and mark the location with a pencil.
2. Based upon this mark, locate the position for the integral magnet in the door or
window and mark the location with a pencil.
Installation and Operations Manual

Figure 53: Installing Recessed DW Sensor

AT&T Proprietary (Internal Use Only)
—85—