Keithley 2601 User Manual page 54

Section 3: Test Script Processor Interaction
1. The Run configuration box is used to launch (load) a user script into the Series 2600 and save
it in non-volatile memory. As shown below, open the Run box and then click Run in the drop-
down menu:
NOTE
2. In the Configurations area of the Run box, select the KIGeneral script. The launch
configuration tabs for that script will appear in the Run box.
3. Presently, the Name of the script is KIGeneral. You should change the name so the script is
not confused with the factory script of the same name that resides in the Series 2600. Change
the script Name to KIGeneralUser and click the Apply button.
4. As shown in
in the Available Project Files area, double-click main.tsp to move the file over.
5. Click the Script Attributes tab to display the load and store options and select the LoadOnly
run action and Non-volatile storage as shown in
6. Click the Apply button to set the run configuration.
7. Click the Run key to load the user script into non-volatile memory of the Series 2600.
NOTE There is small bar graph at the bottom-right of the Test Script Builder
3-8
Figure 3-4 and Figure 3-5
launch is configured.
Figure 3-4, the main.tsp file must be in the Load Order area of the Run box. If it is
that will appear while a script is loading. The bar graph will
continuously sequence through its segments while the script is
loading.
Return to Section Topics
Series 2600 System SourceMeter
show how the Run box will look after the
Figure 3-5.
®
Instruments User's Manual
2600S-900-01 Rev. C / January 2008