Series 2600 System SourceMeter
Note that the reading response will appear in the console window
Alternatively, you can also take and print readings by including the appropriate measure
command as the argument in the print command. For example, the following commands will
take and print ohms and power readings respectively:
print(smua.measure.r())
print(smua.measure.p())
Again, readings will be displayed in the console window.
Step 7: Turn off output
Send the following command to turn off the output when measurements are complete:
smua.source.output =smua.OUTPUT_OFF
Figure 2-6
Source-measure command sequence in console window (2601/2602 version shown)
2600S-900-01 Rev. C / January 2008
®
Instruments User's Manual
Return to
Section Topics
Section 2: Remote Operation
(Figure
2-6).
2-9