Power Cords For The 5104-22C, 9006-22C, Or 9006-22P System; Disconnecting The Power Cords - IBM 9006-22P Servicing
Hide thumbs
Also See for 9006-22P:
- Installing and configuring (148 pages) ,
- Problem analysis, system parts, and locations (134 pages) ,
- Manual (36 pages)
Table of Contents
Advertisement
Procedure
1. Release the rail safety latches (A) as shown in Figure 109 on page 129, then push the system fully into
the rack.
Ensure that the cables and cable management arm move freely, and that they do not catch on
anything.
Figure 109. Placing the system into the operating position
2. Fasten the two front screws (C) to secure the system to the rack.
Power cords for the 5104-22C, 9006-22C, or 9006-22P system
Learn how to disconnect and connect the power cords on systems.
Disconnecting the power cords from an 5104-22C, 9006-22C, or 9006-22P
system
To disconnect the power cords from a system, complete the steps in this procedure.
Before you begin
Note: This system might be equipped with two or more power supplies. If the removing and replacing
procedures require the power to be off, then ensure that all power sources to the system are
disconnected.
Common procedures for servicing or installing features in the 5104-22C, 9006-22C, or 9006-22P system 129
Advertisement
Table of Contents
