7 2 Electrical Requirements
•
Incoming power to the system must be 100 volts AC to
240 volts AC, single phase 50/60 Hz capable of
supplying 1.0 amps.
•
The system power should be supplied through the AC
power cord provided with your system.
•
WARNING: To avoid risk of electric shock, this equipment
must only be connected to a supply mains with protective
earth.
7 3 Unpacking the System
Carefully unpack your Cavitron Plus Ultrasonic Scaler and
verify that all components and accessories are included:
1. Cavitron
Plus
System with Handpiece Cable
®
™
Assembly with swivel
2. Water Line Assembly (Blue) with Filter and Quick
Disconnect
3. Additional Water Line Filter
4. Detachable AC Power Cord
5. Cavitron
Tap-On
Wireless Foot Pedal
®
TM
6. "AA" Batteries (4-Pack)
7. Auxiliary Cable for Tap-On
8. Steri-Mate
Grip (not shown)
®
9. Steri-Mate
Detachable Sterilizable Handpiece
®
10. Cavitron
Ultrasonic Inserts (quantity optional)
®
11. Efficiency Indicator for Cavitron Inserts
12. Literature Packet
7 4 System Installation
•
The Cavitron Plus System is designed to rest on a level
surface. Be sure unit is stable and resting on four feet.
•
The Cavitron Plus System should not be positioned such
that access to the power input and AC power cord are
limited.
•
Placing unit in direct sunlight may discolor plastic
housing.
•
The system has been equipped with a Tap-On
Foot Pedal which was factory synchronized to operate
with the system's base unit. If your office has more than
one Cavitron system with Tap-On
recommended that you mark the Tap-On
and base unit for easy reference as to which Tap-On
Foot Pedal
TM
Wireless
TM
Technology, it is
TM
Foot Pedal
TM
TM
Foot Pedal operates with which base unit. Should
resynchronization be necessary, follow the instructions in
section 7.10.
7 5 Power Cord Connection
•
Verify the Main Power ON/OFF switch, located at the
center front underside of the System, is set to the OFF
(O) position before proceeding.
•
Insert the AC power cord into the power input on the
back of the System.
•
Insert the pronged plug into an AC wall outlet.
7 6 water Supply Line Connection
•
Grasp the Water Supply Line (blue hose) by the end
opposite the quick-disconnect and insert it into the water
inlet connector until fully seated.
•
Connect the quick-disconnect to the dental office water
supply or a Cavitron DualSelect Dispensing System.
•
Inspect all connections to make certain there are no
leaks.
•
To remove the water line from the Cavitron Plus System,
turn off the dental office water supply. Disconnect the
water supply line from the dental office water supply. If
9
a quick-disconnect connector is attached to the end of
the hose, relieve the water pressure by pressing the tip
Press ring to release
water supply tube.