Danfoss VLT AutomationDrive FC 300 Operating Instructions Manual page 9

Hide thumbs Also See for VLT AutomationDrive FC 300:

Design manual (296 pages)

Programming manual (277 pages)

Operating instructions manual (169 pages)

100

101

102

103

104

105

106

Table of Contents

VLT

AutomationDrive FC 300 Operating

Instructions

It is designed and approved suitable for the requirements of Safety Category 3 in EN 954-1. This functionality is called Safe Stop. Prior to integration and

use of Safe Stop in an installation, a thorough risk analysis on the installation must be carried out in order to determine whether the Safe Stop functionality

and safety category are appropriate and sufficient. In order to install and use the Safe Stop function in accordance with the requirements of Safety

Category 3 in EN 954-1, the related information and instructions of the VLT AutomationDrive Design Guide MG.33.BX.YY must be followed! The information

and instructions of the Operating Instructions are not sufficient for a correct and safe use of the Safe Stop functionality!

MG.33.AC.02 - VLT is a registered Danfoss trademark

2 Safety Instructions and General Warning

Table of Contents