Additional Information - Honeywell FBII CP-220A Hookup And Installation Instructions

Central station receiver

page of 190

/ 190
Contents
Table of Contents
Bookmarks

Table of Contents

REMEMBER!

To leave the Programming

Mode at any time, press

the Esc key. Doing so will

return the CP-220A to its

normal operating mode.

Programming changes will

be stored automatically.

Central Stations using Automation Systems usually operate the CP-220A in

its AUTOMATIC Mode and prefer to keep the sounder off, because the

Automation System itself often provides its own "alert" when data

transmissions and error messages are received. However, turning the

sounder off in PARAMETER 57 may not allow operator notification of every

error condition involving the CP-220A.

Programming Options:

If the sounder has been "globally" enabled in PARAMETER 04, use

PARAMETER 57 to choose whether it will be ON or OFF, as desired, in the

CP-220A's AUTOMATIC Mode. If "ON" is selected, the sounder will operate

for 3 seconds each time a message is processed. If "OFF" is chosen, the

sounder will not operate at all in the AUTOMATIC Mode. If you choose to

turn the sounder off, be sure that all error messages unique to the CP-220A

will be annunciated by the Automation System.

Programming Procedures:

After entering PARAMETER 57, [AUTO MODE SOUNDER ON] will be

displayed. Use the NEXT key to toggle between enabling and disabling the

sounder.

Default:

The sounder is factory set to "ON," and will operate for 3 seconds each time

a message is received by the CP-220A in its AUTOMATIC Mode. As stated,

this assumes that the sounder has been "globally" enabled in PARAMETER

04.