REMEMBER!
To leave the Programming
Mode at any time, press the
Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 15:
Computer
Trouble Delay
If either [FBI] or [ADEMCO] receiver emulation was selected in
PARAMETER 02, there is no need to program this parameter, and its
default [48] should be accepted.
Programming Procedures:
When PARAMETER 12 is entered, [HEADER 48] (corresponding to the
ASCII [H]) will be displayed, and the [4] will be flashing. Any ASCII value
between [00] and [FF] may be programmed by using the NEXT key or the
MANUAL/PREVIOUS key to change the first character, as required.
Once this is done, use the
before, use either the NEXT key or the MANUAL/PREVIOUS key to change
it, if necessary. Subsequent movement between the two digits can be
accomplished through the use of the
Default:
The character [H] corresponding to ASCII [48] is the default.
Advancing to Next Parameter:
After programming PARAMETER 12, press the N key to advance to
PARAMETER 15 – the next parameter in Category C.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 12]) with its first digit flashing, indicating its request for the
next parameter number. Press either:
• 1 then 5 , or
• then
• the
NOTE: When the
immediately – not its number.
TROUBLE DELAY 05 SEC MM/DD/YY HH:MM:SS
Background:
If an Automation System is present (and has been accounted for in
PARAMETER 00), the CP-220A will continually monitor its presence and
status, and will display [COMPUTER FAIL] in the event of a computer
failure. PARAMETER 15 determines how long the CP-220A should wait
with the computer "in failure" before it displays this message.
CP-220A Central Station Receiver
Hook-Up and Installation Manual
key to move to the second character and, as
key or the
key and 5 , or
key
is used, the name of the next parameter appears
Section 2: Programming the CP-220A Page 2-81
key.