REMEMBER!
To leave the Programming
Mode at any time, press
the Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 40:
Automatic
Mode Enable
NOTE 2: In the AUTOMATIC mode, messages are not displayed, but are
sent directly to the printer, and if it exists, to the automation
system.
NOTE 3: Refer to page 2-52 for additional information on sounder operation.
Programming Procedures:
Use the NEXT key to toggle between enabling and disabling the sounder.
Bear in mind that setting of PARAMETER 37 has no effect when the
CP-220A is placed in its AUTOMATIC mode.
Default:
The Sounder is "OFF," which means it will sound for 2 seconds and then
stop.
Advancing to Next Parameter:
The next parameter in Category A is PARAMETER 40. Because it is not
sequential, it cannot be reached with a single press of the
to PARAMETER 40, press the N key.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 37]) with its first digit flashing, indicating its request for the
desired parameter number. Press either:
• 4 then 0 , or
• the
NOTE: When the
immediately – not its number.
AUTO MODE
Background:
In Section 1 (on page 2-103) the differences between operating the CP-220A
in its MANUAL and AUTOMATIC modes are explained. Briefly, in the
MANUAL mode, messages received by the unit are stored in a buffer and
then routed to the display each time the NEXT key is pressed.
In the MANUAL mode, only the CP-220A buffers messages as just described.
If a printer and/or an Automation System are used in conjunction with the
CP-220A, each message, as it is processed by the CP-220A – in addition to
being stored by the receiver – will be routed directly to either the printer
and/or Automation System, without requiring that a previous message be
cleared from the CP-220A's display.
CP-220A Central Station Receiver Section 2: Programming the CP-220A Page 2-39
Hook-Up and Installation Manual
key three times
is used, the name of the next parameter appears
M/DD/YY HH:MM:SS
key. To advance