Parameter 04: Sounder - Honeywell FBII CP-220A Hookup And Installation Instructions

PARAMETER 04:
Sounder
REMEMBER!
To leave the
Programming Mode
at any time, press
the Esc key. Doing
so will return the
CP-220A to its
normal operating
mode. Programming
changes will be
stored automatically.
SOUNDER ON
Background:
The CP-220A's Internal Sounder is used to call the operator's attention to an
incoming data transmission or to an error message or condition that
requires attention and will annunciate for several seconds. Central Stations
using Automation Systems may prefer to keep the sounder off because the
Automation System itself often provides an "alert" when data transmissions
and error messages are received. However, turning the sounder off under
these circumstances may prevent operator notification of every error
condition involving the CP-220A. If you choose to turn the sounder off, be
sure that all error messages unique to the CP-220A will be annunciated by
the Automation System.
Programming Procedures:
[SOUNDER ON] will be displayed after entering PARAMETER 04. The
Sounder may be programmed to be ON or OFF, as desired, by pressing the
NEXT or the MANUAL/PREVIOUS key until the desired choice is reached.
Default:
The factory has pre-programmed the sounder to be ON. If kept on, the
sounder will operate regardless of whether the Receiver is in its
AUTOMATIC or MANUAL mode (see page 2-103), and will be subject to the
settings used in PARAMETER 37 (for the MANUAL Mode) and
PARAMETER 57 (for the AUTOMATIC Mode). If kept OFF in
PARAMETER 04, it cannot be turned on by any settings made in either of
the other parameters.
Advancing to Next Parameter:
After programming PARAMETER 04, press the
PARAMETER 05 – the next parameter in Category A.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 04]) with its first digit flashing, indicating its request for the next
parameter number.
You can reach PARAMETER 05 in one of several ways. Press either:
• 0 then 5 , or
• the
• the
NOTE: When the
immediately – not its number.
CP-220A Central Station Receiver
Hook-Up and Installation Manual
key and 5 , or
key
is used, the name of the next parameter appears
Section 2: Programming the CP-220A Page 2-9
MM/DD/YY HH:MM:SS
key to advance to