REMEMBER!
To leave the Programming
Mode at any time, press the
Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 23:
Time Terminator
Once this is done, use the
before, use either the NEXT key or the MANUAL/PREVIOUS key to change
it, if necessary. Subsequent movement between the two digits can be
accomplished through the use of the
Default:
PARAMETER 22 is defaulted to the [SPACE] character, corresponding to
ASCII [20].
Advancing to Next Parameter:
After programming PARAMETER 22, press the N key to advance to
PARAMETER 23 – the next parameter in Category C.
The CP-220A displays the parameter just programmed [PARAMETER
NUMBER 22] with its first digit flashing, indicating its request for the
next parameter number. Press either:
• 2 then 3 , or
• then
• the
NOTE: When the
immediately – not its number.
TIME TERMINATOR 14
Background:
PARAMETER 23 has been factory programmed with the ASCII code [14]
representing the character known as the time terminator, which serves as
the "marker" generated by the CP-220A to indicate the end of the time/date
string it transfers to the computer (see PARAMETER 13 on page 2-86).
PARAMETER 23 was meant to remain as factory programmed, and must
not be altered at any time.
NOTE:
See PARAMETER 11 (on page 2-79) for information on ASCII
coding and the ASCII Character Set.
Programming Procedures
After programming PARAMETER 23, press the N key to advance to
PARAMETER 24 – the next parameter in Category C.
CP-220A Central Station Receiver
Hook-Up and Installation Manual
key to move to the second character. As
key or the
key and 3 , or
key
is used, the name of the next parameter appears
MM/DD/YY HH:MM:SS
Section 2: Programming the CP-220A Page 2-91
key.