Gaining Access - Honeywell FBII CP-220A Hookup And Installation Instructions

Although the CP-220A may seem
imposing to the first-time user, it has
been designed so that its setup and
operation are based on logical steps,
which will be covered in this manual.
Page 1-6 Section 1: Getting Acquainted CP-220A Central Station Receiver
NOTE 2: The CP-220A is equipped with a Line Card
Retaining Bar to prevent its replaceable circuit
cards from being dislodged during shipping. If the
CP-220A is to be rack mounted or will otherwise
remain stationary, the Line Card Retaining Bar
can be removed so that Line Cards may be easily
added or replaced, should that be necessary. This
procedure is explained in Step 3 on page 1-8.
The following steps describe the procedures through which
you can become familiar with your CP-220A and, if desired,
you can remove of the Line Card Retaining Bar.
Step 1: Gaining Access
Before beginning, make sure the CP-220A is not connected
to any source of power – whether it be AC or battery.
a) Remove the four mounting screws that secure the top
cover, located on the left and right sides of the unit.
Pull the cover straight up and off. To avoid misplacing
the screws, partially re-thread them into the holes from
which they were removed. See Figure 1-3.
b) Remove the four screws securing the front panel and
lay the panel face down on a soft surface, as shown in
Figure 1-4. Be careful not to scratch the display
window or separate the front panel's ribbon or wired
cables from their connectors. As before, partially
re-thread the front panel's retaining screws into the
holes from which they were removed, to avoid loss.
Hook-Up and Installation Manual
FIGURE 1-3