Table of Contents
Advertisement
REMEMBER!
To leave the
Programming Mode at
any time, press the
Esc
key. Doing so will
return the CP-220A to
its normal operating
mode. Programming
changes will be stored
automatically.
PARAMETER 29:
Copy Slot
Advancing to Next Parameter:
After programming PARAMETER 28, press the N key to advance to
PARAMETER 29 – the next parameter in Category A.
NOTE: Depending on where the flashing cursor is positioned, it may be
necessary to press the N key twice to advance to the next parameter.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 28]) with its first digit flashing, indicating its request for the next
parameter number.
You can reach PARAMETER 29 in one of several ways. Press either:
• 2 then 9 , or
• the
• the
NOTE: When the
immediately – not its number.
14 3579 39
Background:
Setting up descriptive words to be linked to the CP-220A's Reporting Codes
permits customizing the manner in which events are reported. This was
accomplished in PARAMETER 28. PARAMETER 29 allows the descriptive
words previously programmed into any slot to be copied to any other slot,
assuming that the descriptive language for Codes 0-9 are to be identical in
the slot(s) selected. Doing so provides a great convenience for the individual
who programs the CP-220A, in that the choices of descriptive wording may
have to be identical for several or more Line Cards in the receiver.
Programming Procedures:
[COPY SLOT 1 TO SLOT 1] will be displayed after entering PARAMETER
29, and the [1] after the first occurrence of [SLOT] will be flashing. At this
time, the descriptive wording used for any slot (Line Card) can be copied to
any other slot (Line Card), as required. The parameter is designed to copy
only one slot at a time, but by repeating the process, copying among several
slots can be easily performed.
Copying from One Slot to Another:
1.
With the first [1] flashing, use the keypad to enter the number of the
"source" slot (whose descriptive wording is to be copied elsewhere). If
Slot 1 has been selected as the "source," simply depress the
move past the [TO SLOT] field; the second [1] will flash.
CP-220A Central Station Receiver Section 2: Programming the CP-220A Page 2-27
Hook-Up and Installation Manual
key and 9 , or
key
is used, the name of the next parameter appears
10/25/94 23:15:55
key to
Hide quick links:
Advertisement
Table of Contents
