Parameter 53: Acron 11-Digit With Zero Or Space - Honeywell FBII CP-220A Hookup And Installation Instructions

REMEMBER!
To leave the Programming
Mode at any time, press the
Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 53:
Acron 11-Digit
With Zero or
Space
Data received by the
CP-220A in the Acron
Superfast format and
transferred to the
Automation System
through the receiver's
DTE Port is assembled
as shown at the right.
PARAMETER 53 is
used to determine what
the first character of the
Account Number will be
if only three digits are
being used.
NOTE: The Automation
"handshaking" technique, or the default of [00] must be
programmed
Default:
PARAMETER 52 is defaulted to [XOFF 00].
Advancing to Next Parameter:
After programming PARAMETER 52, press the N key to advance to
PARAMETER 53 – the next parameter in Category C.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 52]) with its first digit flashing, indicating its request for the
next parameter number. Press either:
• 5 then 3 , or
• then
• the
NOTE: When the
immediately – not its number.
ACRON 11 DIGIT W/ZERO MM/DD/YY HH:MM:SS
Background:
When the CP-220A receives a message in the Acron Superfast format, it
outputs the message to its DTE (and DCE) ports in the manner depicted
below:
CP-220A Central Station Receiver
Hook-Up and Installation Manual
System must
.
key and 3 , or
key
is used, the name of the next parameter appears
Section 2: Programming the CP-220A Page 2-99
support the XON/XOFF