Parameter 27: Channel English - Honeywell FBII CP-220A Hookup And Installation Instructions

PARAMETER 27:
Channel English
Page 2-30 Section 2: Programming the CP-220A CP-220A Central Station Receiver
CHANNEL 1 CHAN ONE MM/DD/YY HH:MM:SS
Background:
PARAMETER 27 has been incorporated into the CP-220A so that English
language displays and printouts will be possible when subscriber messages
are received in the ADEMCO High Speed Format (also known as ADEMCO
Superfast). The ADEMCO High Speed Format is unique in that it provides
simultaneous information about each of the zones in the protected premises
– and transmits them every time an alarm is sent to the Central Station.
NOTE 1: It is not necessary to enter PARAMETER 27 if there are no plans
to process messages in this format.
NOTE 2: The concepts in the ADEMCO High Speed Format differ from
other communication formats discussed so far. Appendix B
provides
communication format capable of being processed by the CP-220A.
Once PARAMETER 27 is selected, the CP-220A will display [CHANNEL 1
CHAN ONE]. The ADEMCO High Speed (Superfast) Format can
simultaneously process up to 8 channels of information, for which the
following English language descriptors have been assigned as defaults:
Channels 1 through 8 refer to either separate zones or groups of zones being
reported in the ADEMCO High Speed Format by a control panel or a
separate digital communicator transmitting information to the CP-220A.
Unless changed through programming (see below), the English words in the
table will be displayed on the CP-220A and its associated printer whenever a
Code 1 (representing an alarm) is transmitted on any of the 8 channels.
If desired, the English language descriptors may be reprogrammed for any
or all of the 8 reporting channels of a subscriber's account, whenever it sends
a "Code 1" (alarm) message in this format. As many as 12 characters can be
programmed for each of these channels; doing so will require movement
between the Channel Number and the English Word fields on the display. As
in PARAMETER 28, characters may be scrolled through the array with the
NEXT key or the MANUAL/PREVIOUS key, as described in the following
section.
additional information
CODE ENGLISH WORD
1 ONE
2 TWO
3 THREE
4 FOUR
Hook-Up and Installation Manual
on this and any
CODE ENGLISH WORD
5 FIVE
6 SIX
7 SEVEN
8 EIGHT
other