Introduction; Preparation For Programming; No External Connections Made - Honeywell FBII CP-220A Hookup And Installation Instructions

Section 2
Programming the CP-220A Receiver

Introduction

Preparation
for
Programming:
No External
Connections
Made
Section 2 will take you through the "ins" and "outs" of programming your
CP-220A Receiver and will explain each of the 63 parameters used in
configuring the product. As stated in Section 1, each of these parameters has
been factory pre-programmed with defaults that reflect the common usages
and applications of the Receiver. In many cases, only a few of these
parameters may have to be re-programmed to satisfy the needs of the
Central Station.
All programming is done from the keyboard on the CP-220A's front panel.
Because the CP-220A's electronic memory is "non-volatile" – that is, it
retains data without the need for external power – all sources of power can
be removed from the Receiver without losing the current configuration.
The 63 parameters span a range from 00 through 62. It is possible to
program each one in turn, beginning with 00 and ending with 62, but the
approach taken in Section 2 will be to group all the related parameters into
these three categories whose numbers are not always consecutive:
• Category A: Receiver Operation
• Category B: Printer Operation
• Category C: Computer (Automation System) Operation
Because not all Central Stations have a printer or an Automation System
connected to their CP-220A at this time, it may not be necessary to program
the parameters used for these devices until they're incorporated with the
Receiver.
If you choose to enter programming without making the external
connections discussed on page 1-17, perform the preliminary actions in the
steps detailed on the next page.
If you have already made these connections, proceed to Preparation for
Programming: External Connections Have Been Made, on page 2-4.
• Insert the CP-220A's AC Line Cord into an unswitched electrical outlet
supplying 120 Volts AC at 60 Hertz.
• During the next 25 seconds (approximately) while the CP-220A performs
some self-checks, its internal sounder will annunciate and several relay
activations may be heard. The MANUAL/PREVIOUS LED will illuminate,
and the NEXT LED will light soon after.
CP-220A Central Station Receiver
Hook-Up and Installation Manual
Section 2: Programming the CP-220A Page 2-1