Parameter 10: Serial Stop Bits - Honeywell FBII CP-220A Hookup And Installation Instructions

REMEMBER!
To leave the Programming
Mode at any time, press the
Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
PARAMETER 10:
Serial Stop Bits
REMEMBER!
To leave the Programming
Mode at any time, press the
Esc key. Doing so will
return the CP-220A to its
normal operating mode.
Programming changes will
be stored automatically.
Page 2-78 Section 2: Programming the CP-220A CP-220A Central Station Receiver
Advancing to Next Parameter:
After programming PARAMETER 09, press the N key to advance to
PARAMETER 10 – the next parameter in Category C.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 09]) with its first digit flashing, indicating its request for the
next parameter number. Press either:
• 1 then 0 , or
• the
NOTE: When the
immediately – not its number.
SERIAL STOP BITS IS 2 MM/DD/YY HH:MM:SS
Background:
In PARAMETER 10, the Serial Stop Bits specify the number of bits (either
1 or 2) that follow each character of data sent by the CP-220A to mark
where one character ends and the next character begins.
Programming Procedures:
The number of Stop Bits programmed for the CP-220A must be set to match
that which was chosen for the computer (or vice versa). Choose either [1] or
[2] by pressing either the NEXT key or the MANUAL/PREVIOUS key, as
required.
Default:
PARAMETER 10 is defaulted to [2] Stop Bits. As stated, if this value is
used, the Automation System's computer must also be programmed for 2
Stop Bits.
Advancing to Next Parameter:
After programming PARAMETER 10, press the N key to advance to
PARAMETER 11 – the next parameter in Category C.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 10]) with its first digit flashing, indicating its request for the
next parameter number. Press either:
• 1 then 1 , or
• then
• the
NOTE: When the
immediately – not its number.
key
is used, the name of the next parameter appears
key and 1 , or
key
is used, the name of the next parameter appears
Hook-Up and Installation Manual