REMEMBER!
To
leave
the
Programming Mode
at any time, press
the Esc key. Doing
so will return the
CP-220A
to
its
normal
operating
mode. Programming
changes
will
be
stored automatically.
PARAMETER 08:
Handshake Delay
Page 2-16 Section 2: Programming the CP-220A CP-220A Central Station Receiver
Advancing to Next Parameter:
After programming PARAMETER 07, press the N key to advance to
PARAMETER 08 – the next parameter in Category A.
The CP-220A displays the parameter just programmed ([PARAMETER
NUMBER 07]) with its first digit flashing, indicating its request for the next
parameter number.
You can reach PARAMETER 08 in one of several ways. Press either:
• 0 then 8 , or
• the
• the
NOTE: When the
immediately – not its number.
SLOT 1 DELAY IS 1 SEC
Background:
After waiting
the
PARAMETER 06 on page 2-12) before picking up on an incoming call, the
Line Cards in the CP-220A can be programmed to wait an additional
number of seconds, called the Handshake Delay, before transmitting the
handshake signal(s) as programmed into PARAMETER 07. Such a delay
may be desirable or even necessary if the nature of the telephone line
connection requires a "settling" period before becoming stable enough to
process the data transmitted by a Digital Communicator. As such, a one-
second delay has been set up as the default for each of the 8 slots in the
CP-220A.
Programming Procedures:
[SLOT 1 DELAY IS 1 SEC] will be displayed after entering PARAMETER
08. The number [1] after [SLOT] will be flashing. Each of the 8 slots can be
programmed to delay the onset of the handshake signal between 0 and 9
seconds after answering an incoming call.
If it is necessary to change the Handshake Delay that Slot 1 will provide,
take the following steps:
1.
Depress the
key once. The [1] indicating the number of seconds will
begin to flash. At this time the delay period may be altered.
2.
Press the key representing the number of seconds appropriate for Slot 1
(i.e., press 2 for two seconds). The chosen number of seconds will be
assigned to Slot 1.
3.
Press the
key so that the [1] after [SLOT] flashes again.
key and 8 , or
key
is used, the name of the next parameter appears
MM/DD/YY HH:MM:SS
pre-programmed
Hook-Up and Installation Manual
number
of
Ring
Signals (see