Call Park - Yealink CP920 User Manual

User Guide for the CP920 HD IP Conference Phone
Enter the number of the new party and then tap
6.
When the new party answers the call, tap the Conf soft key to add the new party to the
7.
conference.
Repeat steps 5 to 7 until you have added all intended parties.
8.
The procedures to set up a network conference call on specific servers may be different from
that introduced above. Contact your system administrator for more information.

Call Park

You can use call park feature to place a call on hold, and then retrieve the call from another
phone in the system (for example, a phone in another office or conference room). You can park
an active call by tapping the Park soft key on the phone. If the call is parked successfully, there
is a voice prompt confirming that the call was parked. You can retrieve the parked call by
tapping the Retrieve soft key. If the parked call is not retrieved within a period of time defined
by the system, the phone performing call park will receive the call back.
Call park is not available on all servers. Contact your system administrator for more information.
Note
The IP phone supports call park feature under the following modes:
FAC mode: park the call to the local extension or a desired extension through dialing the

park code.
Transfer mode: park the call to shared parking lot through performing a blind transfer to

a call park number (call park code).
You can select to use any of above modes according to your server.
The call park code and park retrieve code are predefined on the system server. Contact your
Note
system administrator for more information.
FAC Mode
To configure call park feature in FAC mode via web user interface:
Click on Features->Call Pickup.
1.
Select FAC from the pull-down list of Call Park Mode.
2.
Select Enabled from the pull-down list of Call Park.
3.
If Enabled is selected, the Park soft key will display on the LCD screen during a call, and
the Retrieve soft key will display on the dialing screen.
(Optional.) Enter the call park code in the Call Park Code field.
4.
It is configured for the Park soft key.
(Optional.) Enter the park retrieve code in the Park Retrieve Code field.
5.
96
, , or the Send soft key.