Step 4: Install Megaraid Scsi - LSI MegaRAID SCSI 320-0 Zero-Channel RAID Controller Series 520 Hardware Manual

6.2.3.4 J8 Connector for Optional BBU Daughter Card
6.2.4

Step 4: Install MegaRAID SCSI 320-0

J8 is 40-pin connector that is used to mount an optional battery backup
unit that is on a daughtercard.
Select the ZCR 3.3 V or 5 V PCI slot and align the MegaRAID SCSI
320-0 controller bus connector with the slot.
differences between the 3.3 V and 5 V slots.
Figure 6.2 3.3 V and 5V Slots
Note: The slot must be a specific ZCR slot on a motherboard that
has an installed LSI Logic 53C1030 SCSI chip; see your
motherboard manual for this information.
Insert the MegaRAID SCSI 320-0 card in the ZCR PCI slot, as shown in
Figure 6.3. Press down gently but firmly to make sure that the card is
properly seated in the slot. The bottom edge of the controller card should
be flush with the slot. Attach the bracket to the computer frame with the
bracket screw.
Installation Steps
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Figure 6.2 shows the
6-5