6.2.2
Step 2: Power Down
6.2.3
Step 3: Set Jumpers
·
The Driver and Documentation CD, which contains these items:
–
The MegaRAID Configuration Software Guide
–
The MegaRAID Operating System Driver Installation Guide
–
The MegaRAID SCSI 320-0 ZCR Hardware Guide
–
The software license agreement
–
The MegaRAID SCSI 320-0 configuration utilities for DOS
·
The warranty registration card
Turn off the computer, remove the power cord, then remove the cover.
Make sure the computer is turned off and disconnected from any
networks before installing the controller card.
Make sure the jumper settings on the MegaRAID SCSI 320-0 card are
correct. The jumpers are set at the factory and you probably do not need
to change them.
Table 6.2
Table 6.2
Jumpers for the MegaRAID SCSI 320-0
Item
Description
J2
Dirty cache LED
J3
Clear EPROM
J4
BIOS enable
J8
BBU daughter card connector 40-pin connector
Figure 6.1
shows the location of these items on the MegaRAID SCSI
320-0 controller.
Installation Steps
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
lists the jumpers (and a connector).
Type
2-pin header
2-pin header
2-pin header
6-3