Step 6: Run The Megaraid Bios Configuration Utility; Step 7: Install The Operating System Driver - LSI MegaRAID SCSI 320-0 Zero-Channel RAID Controller Series 520 Hardware Manual

6.2.6

Step 6: Run the MegaRAID BIOS Configuration Utility

6.2.7

Step 7: Install the Operating System Driver

The firmware takes several seconds to initialize. During this time the
adapter will scan the SCSI channel(s). When ready, the following
appears:
Host Adapter-1 Firmware Version x.xx DRAM Size 16 MB
0 Logical Drives found on the Host Adapter
0 Logical Drives handled by BIOS
Press <Ctrl><M> to run MegaRAID SCSI 320-0 BIOS
Configuration Utility
The <Ctrl><M> utility prompt times out after several seconds. The
MegaRAID SCSI 320-0 host adapter (controller) number, firmware
version, and cache DRAM size are displayed in the second portion of the
BIOS message. The numbering of the controllers follows the PCI slot
scanning order used by the host motherboard.
Press <Ctrl><M> to run the MegaRAID BIOS Configuration Utility. See
the MegaRAID Configuration Software Guide for information about
running this utility.
MegaRAID can operate under MS-DOS or any DOS-compatible
operating system using the standard AT BIOS INT 13h Hard Disk Drive
interface. To operate with other operating systems, you must install
software drivers. MegaRAID provides software drivers on the Driver and
Documentation CD for the following operating systems:
·
MS-DOS version 6.xx or later
·
Microsoft Windows NT 4.0, Windows 2000, Windows XP, Windows
.NET
·
Novell NetWare 5.1, 6.0
·
Red Hat Linux 7.2, 7.3
Note: Refer to the MegaRAID Driver Installation Guide for the
procedures used to install operating system drivers.
Important: When booting the system from a drive connected to a
MegaRAID controller and using EMM386.EXE,
MEGASPI.SYS must be loaded in CONFIG.SYS before
Installation Steps
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
6-7