Chapter 7 Troubleshooting; General Troubleshooting - LSI MegaRAID SCSI 320-0 Zero-Channel RAID Controller Series 520 Hardware Manual

7.1

General Troubleshooting

Table 7.1 General Problems and Suggested Solutions
Problem
The system hangs during the boot
process after installation.
Some operating systems do not load in
a computer with a MegaRAID SCSI
320-0 adapter.
Chapter 7
Troubleshooting
This chapter provides troubleshooting information for the MegaRAID
SCSI 320-0 controller. It contains the following sections:
·
Section 7.1, "General Troubleshooting"
·
Section 7.2, "BIOS Boot Error Messages"
·
Section 7.3, "Other BIOS Error Messages"
·
Section 7.4, "Other Potential Problems"
This section lists the general problems that can occur, along with
suggested solutions.
encounter, along with suggested solutions.
Suggested Solution
Make sure the SCSI BIOS on the motherboard has been
disabled.
Make sure the MegaRAID SCSI 320-0 adapter card is
installed in the proper PCI expansion slot. It must be
installed in the RAID Upgrade PCI slot.
Check the system BIOS configuration for PCI interrupt
assignments. Make sure some Interrupts are assigned for
PCI.
Initialize the logical drive before installing the operating
system.
MegaRAID SCSI 320-0 Hardware Guide
Copyright © 2002 by LSI Logic Corporation. All rights reserved.
Table 7.1 describes general problems you might
7-1