Combining Mls, Leds And Channels; Fx Programming Tools - Philips 64331 Operation Manual

Operations Manual
7) Press Flash Button 1 . It will go out. The first scene is now stored in this button.
8) Set channels 5 to 8 at FL .
9) Set the FD/ST TIME button to Step mode (it will be yellow). Set the STEP RATE Fader to 2.00, you can
see the step time changing in the lower left window of the LCD.
10) Set the FD/ST TIME button to Time mode (it will be red). Set the STEP RATE Fader to 1.00. You can see
the fade time changing in the lower left window of the LCD.
11) Press Flash Button 2 . It will go out. The second scene is stored in this button.
12) Set channels 9 to 12 at FL .
13) Set the FD/ST TIME button to Step mode (it will be yellow). Set the STEP RATE Fader to 5.00, you can
see the step time changing in the lower left window of the LCD.
14) Set the FD/ST TIME button to Time mode (it will be red). Set the STEP RATE Fader to 4.00. You can see
the fade time changing in the lower left window of the LCD.
15) Press Flash Button 5 . It will go out. The third scene is stored in this button.
16) Press SOFTKEY C "Record FXBase" . This will store the FX 2 stack. The FX 2 button will turn red. You
will return to Single Scene Mode .
To playback the chase you have recorded:
1) Press FX 2 . It will turn yellow to show the stack is selected.
2) Press START/STOP to activate FX2 . The first scene will playback and FX2 will flash red to show it is
active. The display on the monitor will show the 3 scenes running automatically.
Note: Even though you have recorded this as an auto chase you can over-ride it and run it manually. Once you have
started the chase running, press FX2 so it turns yellow. Set the FD/ST TIME button Step mode. Set the STEP RATE
fader to Manual . You can now use the GO/STEP button to step through the chase. If you want to return to the chase
then press the FX2 button again and the chase will automatically run.

3. Combining MLs, LEDs and Channels

It is possible to make up an FX stack that combines channels, LEDs and MLs (moving lights). Select the FX stack
that you want to record into by pressing RECORD and then the relevant FX key.
Example:
1) Go into Single Scene by pressing the SINGLE SCENE button twice (it will turn Green). You can now set
your channel levels.
2) Once you have finished setting your channel levels press ML . Select the moving lights and then set the
attributes as required.
3) Once you have finished setting your MLs press LED . Select the LEDs you require and set the attributes as
required.
4) Press the FX button you originally selected (it will be flashing blue).
5) Select which scene you want to store the look in and press the relevant flash button.
6) You can continue until you have stored all the scenes you require and then play them back as described
above.
NOTES:
• Remember when going into Single Scene to press the button twice, it needs to be Green to be active.
• Remember to release the LEDs and MLs when you have finished recording them.
• Be aware that this console tracks. If you change a parameter on an LED or ML in one step it will not change until
you make a change in a later step.

4. FX Programming Tools

This section covers available FX programming tools.
5 0
FX MODE