Using Your Moving Lights - Philips 64331 Operation Manual

Operations Manual
• Use SOFTKEY D to select the fixture that you want. The LCD screen will change to allow you to set the start
address for the fixture you have selected.
It is possible to change the DMX address using the FX 1 through FX 10 keys. (FX10 is 0).
The Flash buttons that have no fixture assigned to them will be flashing. Press a Flash button to assign a fixture to it.
It is possible to assign more than one fixture at the same time. If you wish to assign 4 fixtures of the same type, press
and hold the flash button where you wish to store the first one. Then press and the flash button 4 along. You will now
have patched 4 fixtures of the same type.
Note: The 200 Plus will not allow you to over-patch fixtures. You will get a warning if you try and do this.
Repeat these steps until you have patched all the fixtures you have. When you have completed this process press
Menu to leave the set up functions.
Note: To create a new or your own fixture library, see
LIBRARIES" on page

Using your Moving Lights

Now that the moving lights are patched, the Preset A faders are used to set the intensity of the fixtures. The Preset
A Flash buttons are used to select fixtures. Once a fixture is selected it is possible to adjust its various parameters.
The monitor display will provide you with information about the moving lights and their attributes as shown in
Figure 25 on page 27.
2 6
CONSOLE ADVANCED OPERATION
Fixture Patch
Menu
Release
Pat. ELA36LTB1
to DMX [215]
Press Bump
DMX Base
Button To Patch
FX
Master: xxx
Figure 24: ML Starting Address - LCD Display
70.
Other
Fix
Exit
"CREATING MOVING LIGHT (ML) AND LED FIXTURE
A
B
C
D