Connecting Power To The Homebase; Charging The Main Battery; Charging A Spare Battery In The Auxiliary Battery Well; Power - Honeywell Dolphin 75e User Manual

Preliminary Draft, Not for Release - Please Review 2-3-2015

Connecting Power to the HomeBase

1. Plug the A/C power cord into the power adapter.
2. Plug the power cable into the power connector on the back
of the HomeBase.
3. Plug the A/C power cord into a grounded power source.
4. The base is now powered.

Charging the Main Battery

The base provides power to the Dolphin terminal and allows the charging of the terminal's battery. The intelligent battery
charging system incorporated into all Dolphin terminals prevents overcharging, which means that Dolphin terminals may be
stored in the base indefinitely without damage to the terminals, battery, or the base. When the terminal is docked, the base
completes a full charge in 4 hours for the standard battery or 6 hours for the extended battery.
For more information about Honeywell battery packs and how to check battery power levels in your terminal, refer to
(page 3-8).
To Power a Terminal and Charge its Main Battery
Ensure all components are dry prior to mating terminals/batteries with peripheral
devices. Mating wet components may cause damage not covered by the warranty.
1. Install the battery pack in the terminal; see
2. Slide the terminal into the terminal well. The Dock LED illuminates blue. Battery charging
begins immediately if required by the Dolphin terminal.
Note: When the terminal is docked, the Battery Icon changes from
terminal is running on external power. Battery charging occurs in the background. When
the Dolphin is removed from the base, the battery icon indicates the charge level of the
battery, see Common Status and Notification Icons
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in damage
not covered by the warranty.

Charging a Spare Battery in the Auxiliary Battery Well

The auxiliary battery well located on the back of the base charges a spare battery independently of the terminal well. The Aux
Battery LED on the front panel indicates the status of the battery in this well. Charge time is 4 hours for the standard battery
pack or 6 hours for the extended battery pack; see
1. Insert the battery at an angle.
Note: Align the battery contacts with the contacts inside the auxiliary battery
well.
2. Snap the battery into place with a hinging motion. The Aux Battery LED lights
orange during charging.
3. Use the AUX Battery LED to monitor the charging progress. The LED changes to
green when the auxiliary battery has completed charging and is ready for use.
A/C Power Cord
Install the Battery on page 2-1.
to
on page 2-6.
Auxiliary Battery Well on page
Power Adapter
indicating the
9-4.
Power Cable
Battery
9 - 5