TouchCenter Initialization
Power Up
When initially powered, the screen displays the boot sequence as it is
performed. After it is determined what services are available, the
screen displays the Set ECP Address screen.
SCREEN
How to Change the ECP Address
After enabling addresses in the control panel using an alpha-keypad,
power up each TouchCenter one at a time, and set its address to one
of the addresses you enabled in the control panel. If this is a first
time power-up of the unit, follow the initialization procedure in this
section. Otherwise, access the Central Station screen then follow the
procedure to change the address on the unit.
Language Selection
The 6271C, 6271CS, and 6271CB has the functionality to display
three different languages (English, French and Spanish) with the
default being English.
How to Select a Language
SCREEN
SECTION 4: Initial Setup
ACTION
If the system is incorporating only one
TouchCenter
, leave the address set to 1
and press the APPLY button. The boot-
up process will continue until completion.
If there are to be additional
units in the system, refer to the How to
Change the ECP Address paragraph.
ACTION
After the initial ECP selection is set, the
"Languages" screen is displayed.
Select from English, Spanish or French
and click OK. If Cancel is selected, the
keypad will be displayed in English.
TouchCenter
4–3