Back Panel - Honeywell Dolphin 75e User Manual

Preliminary Draft, Not for Release - Please Review 2-3-2015

Back Panel

Power Supply Connector
This connector receives input from the power adapter. Plug the power connector cable from the power adapter into this
connector.
Bottom Panel
For details on how to mount the base, see
Serial Number Label
Power
The terminal requires 12 Volts DC input for battery charging and power output to the terminal. The power adapter included with
the base, converts the voltage from the AC power source to 12 volts DC. Use only a UL Listed power supply, which has been
qualified by Honeywell with output rated at 12VDC and 5 amps with the device. The operating temperature range is -10° to
50°C (14° to 122°F).
Honeywell recommends that you leave the ChargeBase connected to its power source at all times, so that it is always ready to
use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
Power Supply Connector
Mounting the ChargeBase
Compliance Label
on page 12-4.
12 - 3