Connecting Usb Devices; Connecting An Ac/Dc Power Supply - Honeywell Marathon User Manual

Connecting USB Devices

The Marathon provides two Type A USB ports behind the access door on the right side of the device. USB devices may be
installed and removed or swapped without turning off the Marathon. When the USB ports are not in use, keep the port cover
door closed.
1. Open the port cover on the right side of the Marathon.
2. Plug the desired device, such as a USB mouse or storage device, or a USB tethered scanner into the USB port. Refer to
Start > Help and Support and the documentation for your USB device for more information.
The Marathon accepts only USB tethered scanners. The scanner is connected to one of the USB ports on the right side of the
Marathon.
If the tethered scanner does not have it's own power supply, e.g., installed rechargeable battery, the tethered scanner draws
power from the Marathon battery.

Connecting an AC/DC Power Supply

Note: The Honeywell-approved AC Power Supply and Adapter Cable are only intended for use in a 25ºC (77ºF) maximum
ambient temperature environment.
In North America, this unit is intended for use with power supply models FX1301PWRSPLY or FX1302PWRSPLY. The external
power supply may be connected to either a 120V, 60Hz supply or, outside North America, to a 230V, 50Hz supply, using the
appropriate detachable cordset. In all cases, connect to a properly grounded source of supply provided with maximum 15 Amp
overcurrent protection (10 Amp for 230V circuits).
1. Turn the Marathon off.
2. Connect the detachable cordset provided by Honeywell (US only, all others must provide their own cable) to the external
power supply (IEC 320 connector).
3. Plug the 3-prong end of the cordset into a grounded electrical supply receptacle (AC mains).
4. The LED on the AC adapter illuminates.
5. Open the port cover on the left side of the Marathon. When the power connector is not used, keep the port cover door
closed.
6. Plug the barrel end of the power cable into the Marathon.
7. The Marathon Battery Status LED at the upper left, next to the screen, illuminates orange to indicate the main battery is
recharging using power from the AC Adapter.
8. Turn the Marathon on.
2 - 11