Bottom Panel - Honeywell Dolphin 75e User Manual

Preliminary Draft, Not for Release - Please Review 2-3-2015

Bottom Panel

For details on how to mount the base, see
Serial Number Label
Power
The terminal requires 12 Volts DC input for battery charging and power output to the terminal. The power adapter included with
the base, converts the voltage from the AC power source to 12 volts DC. Use only a UL Listed power supply, which has been
qualified by Honeywell with output rated at 12VDC and 5 amps with the device. The operating temperature range is -10° to
50°C (14° to 122°F).
Honeywell recommends that you leave the Net Base connected to its power source at all times, so that it is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
Connecting Power to the Net Base
1. Plug the A/C power cord into the power
adapter.
2. Plug the power cable into the power connector
on the back of the Net Base.
3. Plug the A/C power cord into a grounded
power source.
4. The base is ready to begin charging terminals.
Charging the Main Battery
The base provides power to the Dolphin terminals
and allows charging of the batteries in the
terminals. The battery of each terminal charges in 4 hours for the standard battery or 6 hours for the extended battery. The
intelligent battery charging system incorporated into all Dolphin terminals prevents overcharging, which means that Dolphin
terminals may be stored in the base indefinitely without damage to the terminals, battery packs, or the base.
For more information about Honeywell battery packs and how to check battery power levels in your terminal, refer to
(page 3-8).
To Power a Terminal and Charge the Main Battery
Ensure all components are dry prior to mating terminals/batteries with peripheral devices. Mating wet
components may cause damage not covered by the warranty.
13 - 4
Mounting the Net Base
Compliance Label
A/C Power Cord
on page 13-6.
Power LED
Power Adapter
MAC Address Label
Power Connec
Cable
Battery