Power Managementê; Power Settings - Honeywell VISTA Series User Manual

This option is used to set the extent of matching between an input fingerprint and that stored in templates. For
details, see 2.3 Match Threshold.
7)1:1 Lvl
This option is used to set the extent of matching between an input ID/fingerprint and that stored in templates
in the ID and fingerprint identification mode. For details, see
8)Ext FP Dev ê
If you select "Y", you can install an external fingerprint sensor through the USB interface and use this external
sensor together with the fingerprint reader accompanied with the FRT. If you select "N", you cannot install any
external fingerprint sensor. For details, see Appendix External Connection with the Fingerprint Reader.
9)Firmware Upd
You can select "Firmware Upd " to upgrade the firmware of an FRT through the upgrade files in the USB pen
drive.
Note: If you need firmware upgrade files, please contact our technical support engineers. Generally it is not
recommended to upgrade the firmware.
10)Buzzer
This parameter is used to set whether to play voice prompts during the operation of the terminal. Select "ON"
to enable the voice prompt, and select "OFF" to mute.
11)Anti­Passbackê
This option has four values: None, Exit, Entry and Entry and Exit. For details, see Appendix Anti­Passback.
12) Alg Ver
This option is used to set the version number of the fingerprint algorithm. Select 9 to adopt algorithm version
9.0 and 10 to adopt algorithm version 10.0. Please select the algorithm version with caution because the
fingerprint templates of these two algorithm versions are incompatible.
Note: some of the device will be prompted to remove the user information and attendance data when change
the algorithm. So we proposed to back up user information and attendance data before change the algorithm.
Note:
1. The options Two Sensor and Upd Firmware are available only on the USB­capable FRTs.
2. The option Card Only is available only on the Mifare­card­capable or ID­card­capable FRTs.
3. The options R.card Only and FPCard Key are available only on the Mifare­card­capable FRTs.
4. The options Remote Verify and Server IP are available only on the RIS­capable FRTs.
5. The options Keypad Tone and Adj VOL are available only on the FRTs that adopt the URU sensor.
6. The option Work Code is available only on the FRTs that support the work code feature.
7. The option Imdt Prt is available only on the print­capable FRTs.
8. The option Anti Passback is available only on the anti­passback­capable FRTs.
4.2 Power Managementê
Through power management, you can set the timing power­on/shutdown, power­on/shutdown time, lock
power key, and timing state switching.
4.2.1 Power Settings
Press Menu to access system menu. Select Options → Power Mgt to display the following interface.
Honeywell VISTA Series Products User Manual
Power Mgt
►PowerOn
Sleep
Idle
IdleTime
­ 16
2.3 Match Threshold.
▼
N
N
SLP
0