GE Reason H49 Technical Manual page 82

Technical Manual
Attribute
Enable Check the box to enable a port.
Reason H49 interfaces can be configured either as access ports or a trunk ports, as follows:
•
Interface Mode
•
Caution:
Wrong VLAN setting on access ports may cause communication failure with Reason H49.
In such a case, you shall reset the switch to factory-default configuration, as explained in
section "Revert to Default Factory Configuration".
Select the link mode to be used for copper SFP (10Mbps Full Duplex, 100Mbps Full Duplex, 1000Mbps Full
Duplex, Auto-negotiation)
Link Mode
This attribute is disabled if the interface is optic fiber.
VLAN Tag Check the box to enable the 802.1Q tag for VLAN and Priority Code Point (PCP) tags
Default VLAN ID Enter the default VLAN ID (VID) for untagged devices that connect to that port
Default PCP Enter the default Priority Code Point of the interface (0 to 7)
82
Set the interface attributes as detailed in the table below:
Access: An access port can have only one VLAN configured on the interface; it can carry
traffic for only one VLAN,
Reason H49
(Access port VLAN ID 4)
Trunk: A trunk port can have two or more VLANs configured on the interface; it can carry
traffic for several VLANs simultaneously. Usually trunk link connection is used to connect two
switches or switch to router.
Reason H49
Description
Port 5
(Access port VLAN ID 2)
Port 6
Device D
VLAN 4
Reason H49
Port 4
(Trunk port VLAN ID 1)
GE Reason H49
Device E
VLAN 2
H49/EN M/C22