Cli Commands - GE Reason H49 Technical Manual

GE Reason H49
12.1.4

CLI Commands

Note:
Command parameters are case-sensitive (for example –S has not the same effect as –s)
12.1.4.1 Common parameters
Parameter
-d
-i
-h
-v
-S
-D
-iy
12.1.4.2 H49 System Commands
command parameter
-m
switch
-i
H49/EN M/C22
This section gathers the list of command lines that can be used to configure the
Reason H49 switch.
A command line is a combination of a command name, a parameter name and a
parameter value:
The general format is:
•
command
Example: to set the H49 sub mask, you can type:
All commands support the following parameters:
Displays the command description
Displays information about the configuration
Displays all parameters and values valid for the command
Displays the command version
Saves the settings (make the modifications permanent)
Enables debugging mode.
Displays the configuration in YAML format
Switch
The switch command allows setting the switching mode of the device:
switch [-m <mode>] -S -i
Description
Sets the switching mode
Displays configuration
–parameter value
Effect
Technical Manual
system -n 255.255.0.32
Values
StoreAndForward, adaptative
137