Network Commands - GE Reason H49 Technical Manual

Technical Manual
command parameter
-p
-l
configuration
-S
-f
command parameter
-f
-r
firmware
-U
-u
12.1.4.3

Network Commands

command parameter
-c
-l
vlan -r
-s
-p
142
Management
The following values can be set to save the Reason H49 configuration into the startup
configuration file. It also makes it possible to load a new configuration without reboot.
configuration [-p <configuration>] [-l <filename>] -S
Displays the running or startup configuration settings
Loads the running configuration file (.YAML)
Saves the settings in the startup configuration (running to startup)
Sets the network-related settings to the factory default
The following values can be set to update the firmware of Reason H49 or change the
general configuration for the redundancy mode:
Updates the firmware with a file (.bin)
Changes the redundancy operating mode.
You must restart Reason H49 to apply changes.
Upgrades the firmware from a .tar.gz file. Restart is needed
Url of the upgrade file (.tar.gz file)
VLAN
The following values can be set to configure the Reason H49 VLANs:
vlan [-c <vlan name>] [-l <vlan Id>] [-r <vlan Id>] [-p <port
1>:<port2>...] -S -i
Specifies the name of the VLAN to be created
Specifies the VLAN ID (to be used with the –c parameter)
Removes a port from a VLAN (can be used with the –p parameter) or deletes the VLAN.
To delete a VLAN, the command has to be run into two steps:
1
Remove the related port(s) using vlan -r <VLAN id> -p <port01>.
This will only delete the specified port(s), not the VLAN ID.
2
Then, run vlan -r <VLAN id> to permanently delete the VLAN (ID and
Name),
Specifies the VLAN name to set the port list (to be used with the –p parameter)
List of ports to add, remove or set
Description
Description
Description
GE Reason H49
Values
running, startup
/path/file
Values
HSR, HSR_PRP, PRP, NONE,
QUADBOX
Values
2 to 4094
CE01:CE02...
H49/EN M/C22