IBC TopFix 200 Installation Manual page 40

Step 4: Affix the TRAPEZOIDAL CLAMP
Note:
The heavy-duty adhesive tape can be used from an object and working temperature of 0° C; final adhesion
occurs after approx. 72 h at an ambient temperature of 20° C. The higher the temperatures, the faster this
process is complete.
We do not recommend to bond surfaces below these temperatures as the adhesive agent may become
too hard and prevent adequate adhesion. After adhesion has taken place, low temperatures do not
normally create any problems. Prevent the formation of condensation to safeguard appropriate adhesive
properties, for instance in the event that the materials to be bonded together are at very different
temperatures.

TRAPEZOIDAL CLAMPS are aligned with the adjustable element towards the ridge and affixed to
the surface so that the type TF27 carrier rail can be mounted without tension and it is in contact with
the trapezoidal sheet clamp. Please fully remove the protective foil!
Figure 57: Removing the protective foil
Step 5: Distribute the clamps according to the instructions
Figure 59: Distribute the clamps according to the instructions
40
Version 17.01, as of: 27-Jun-2017
Figure 58: Affixing the trapezoidal clamp