IBC TopFix 200 Installation Manual page 54


The adaptor EC is clamped by the given frame height with the middle clamp G4 and substitutes thus
the outer clamp.
Figure 94 EC adapter with middle clamp G4

Subsequently place the first module onto both carrier rails, loosely tighten it to the outside clamps
respectively the middle clamp including EC adapter and align with the row of roof tiles. You may also
use a piece of string to facilitate alignment. Then tighten the clamps to the tightening torque specified
in Figure 120 in the Appendix. For this purpose, we recommend using a torque wrench with TX40
Torx bit size.

Also tighten all remaining modules in this way. We recommend you start with the bottom row of
modules. Assemble all other rows above once it has been exactly aligned.

Please observe the specifications of the currently valid Z-14.4-660 building surveillance certificate.
54
Version 17.01, as of: 27-Jun-2017
Figure 95 EC adapter frame hights