IBC TopFix 200 Installation Manual page 42

Step 7B: Affix the TRAPEZOIDAL CLAMP to the outer roofing with self drilling screws

When using the self drilling screws, two screws are placed per TRAPEZOIDAL CLAMP.
process, make sure you screw carefully to maintain static properties.

The enclosed self drilling
0.5 mm to 1.5 mm.
Important:
A drill with a diameter of 5.0 mm is mandatory to maintain static properties
Figure 67 Apply the screw
Step 8A: Insert and affix the transverse securing clamp with blind rivets

The transverse securing clamps are affixed next to the trapezoidal clamp on the left and right with a
clearance of approximately 20 mm.

There must be a minimum of two transverse securing clamp per string (15.60 m).
Important:
Mount additional transverse securing clamps on roofs that are particularly exposed to wind.
Figure 69: Insert transverse securing clamps
42
Version 17.01, as of: 27-Jun-2017
screws 5,5x25 are approved for a sheet metal or aluminium thickness of
Figure 68 Trapezoidal clamp screwed
Figure 70: Drilling transverse securing clamps
In this