IBC TopFix 200 Installation Manual page 62

9.4 Mounting modules
Modules can be mounted either horizontally or vertically using Delta supports. Modules up to a module
size of 1.7 m can are suitable for vertical mounting.
 Vertical module – clamps on the long sides
Figure 109: Vertically mounted modules with module carrier rail
 Horizontal module – clamps on the short sides
Figure 110: Horizontally mounted modules with module carrier profiles
 Horizontal module – clamps on the long sides
Figure 111: Horizontally mounted modules without module carrier rail
62
Version 17.01, as of: 27-Jun-2017
In this case, Delta supports are connected using two carrier rails
(TF50+/TF50m/TF60). Modules are then mounted on said carrier
rails.
In this case, Delta supports are connected using two carrier rails
(TF50/TF50m/TF60). Modules are then mounted on said carrier rails.
Please ensure that the modules have been approved for clamping on
the short sides.
In this assembly process, modules are mounted directly on the Delta
support. In this case, no further carrier rails are used. However, two
Delta supports are required per module.