Microwave Data Systems MDS 9810 Installation And Operation Manual page 40

32 MDS 9810 Installation and Operation Guide
Table 6. Command Summary
COMMAND
BUFF [ON, OFF]
Details Page 37
HOPTIME [XSHORT, 16, 20,
25, 32, SHORT, NORMAL,
LONG]
Details Page 40
SEND [n, -n, +n]
Details Page 43
SIMPLEX [ON, OFF]
Details Page 45
SKIP [NONE, 1...8]
Details Page 46
SKIPSYNC [ON/OFF]
Details Page 46
TDD [ON/OFF]
Details Page 47
DLINK [xxxxx]
Details Page 39
DTYPE
[NODE/ROOT/GATE/PEER]
Details Page 39
UNIT [10000–65000]
Details Page 48
DESCRIPTION
ON = Seamless data, OFF = Fast byte through-
put.
Select hop time—XSHORT, 16 ms, 20 ms, 25
ms, 32 ms, SHORT, NORMAL, LONG
Sets/displays re-send count for data packets.
Useful in areas with heavy radio interference.
Program simplex/half-duplex selection.
ON = simplex, OFF = half-duplex
Select combination of frequency operating
zones to avoid.
May be used to suppress transmission of
SYNC messages in skipped zones. (See also
SKIP command). Default setting is OFF.
Sets or displays time-division multiplex status of
DATA INTERFACE connector. (Sometimes
referred to as "simulated full-duplex" mode.)
Set baud rate of diagnostics link
Set radio's operational characteristics for net-
work-wide diagnostics
Program unit address. Used to set a unique
address for network-wide diagnostics.
MDS 05-3301A01, Rev. C