Keyboard Commands; Entering Commands - Microwave Data Systems MDS 9810 Installation And Operation Manual

30 MDS 9810 Installation and Operation Guide
Figure 23. HHT setup display
2. The first of 15 menu items will be displayed. Settings can be
reviewed by pressing the NEXT function (
tings can be changed by pressing the ROLL function (
3. Set up the HHT as listed in Table 5.
Table 5. HHT Operational Settings
Parameter
Re-init HT
Baud Rate=
Comm bits=
Parity Error
Key Repeat
Echo
Shift Keys
Ctl Chars
4. Exit the HHT setup mode by pressing
(Roll) key after the final menu item has been reviewed.
A

6.3 Keyboard Commands

Table 6 is a reference chart of software commands for the transceiver.
See Section 6.4 for detailed command descriptions.

Entering Commands

The proper procedure for entering commands is to type the command,
followed by an
ENTER
command is followed by
values, then
.
ENTER
Invisible place holder
Z E
Setting Parameter
NO Scroll On
1200 Cursor
8,1,n CRLF for CR
OFF Self Test
OFF Key Beep
OFF Screen Size
YES Menu Mode
PROCS
for Exit, or by pressing the
C
keystroke. For programming commands, the
and the appropriate information or
SPACE
key). Parameter set-
key).
A
Setting
33rd
ON
OFF
SLOW
ON
80
LONG
MDS 05-3301A01, Rev. C