Error Messages - Microwave Data Systems MDS 9810 Installation And Operation Manual

MDS 05-3301A01, Rev. C
Here are some additional points to remember when using the HHT:
• Use the
SHIFT
ters.
• Flashing square cursor ( ) denotes letter mode.
• Flashing superscript rectangular cursor ( ) denotes number
mode.
• Use key to edit information or commands being typed
ESC/BKSP
into the terminal.

Error Messages

Below are some HHT error messages you may encounter and their prob-
able causes:
•
UNKNOWN COMMAND
•
INCORRECT ENTRY
•
COMMAND FAILED
fully. Possible software problem.
•
NOT PROGRAMMED
EEPROM or the requested display item was not programmed.
•
TEXT TOO LONG
many characters have been entered.
•
NOT AVAILABLE
but it referred to a currently unavailable choice.
•
PASSWORD INVALID
was not accepted.
•
ACCESS DENIED
level.
• EPROM FAILURE
EEPROM.
MDS 9810 Installation and Operation Guide
key to access numbers; press again to return let-
—Command was not recognized.
—Command format or its arguments invalid.
—Command was unable to complete success-
—Software was unable to program the
—Response to or
OWN
—The entered command or parameter was valid,
—The entered password was invalid, and
—Command is invalid for current password
—The command cannot write to the radio's
INIT
command when too
OWM
31