Detailed Command Descriptions - Microwave Data Systems MDS 9810 Installation And Operation Manual

MDS 05-3301A01, Rev. C
Table 6. Command Summary (Continued)
COMMAND
SNR
Details Page 46
SREV
Details Page 47
STAT
Details Page 47
TDD [ON/OFF]
Details Page 47
TEMP
Details Page 48
UNIT [10000–65000]
Details Page 48
ZONE DATA
Details Page 49
KEY
DKEY
DMGAP [xx]
Details Page 39
TX [xxxx]
Details Page 48
RX [xxxx]
Details Page 43
SETUP
Details Page 44

6.4 Detailed Command Descriptions

The essential commands for most applications are Network Address
( ), Mode, (
ADDR MODE
the additional commands allows you to tailor the transceiver for a spe-
cific use, or to conduct basic diagnostics on the radio. This section gives
more detailed information for many of the user commands listed in
Table 6.
Most of the commands below can be used in two ways. First, you can
type only the command name (for example,
programmed data. Second, you can set or change the existing data by
typing the command, followed by a space, and then the desired entry
(for example,
ADDR 1234
variables, if any, are shown in brackets [ ] following the command
name.
MDS 9810 Installation and Operation Guide
Signal-to-noise ratio. Expressed in dB.
Display transceiver firmware revision level
Show current alarm status
Sets or displays time-division multiplex status of
DATA INTERFACE connector. (Sometimes
referred to as "simulated full-duplex" mode.)
Transceiver's internal temperature (°C)
Show programmed unit address for net-
work-wide diagnostics
Show zone data statistics (see text for details).
Press "Q" to quit.
Enables the transmitter.
(Radio must be in Setup mode.)
Disables the transmitter.
(Radio must be in Setup mode.)
Sets the amount of time to wait after the
receipt of a character before interpreting the
next received character as the start of a new
message.
Set/display transmit test frequency.
(Radio must be in Setup mode.)
Set/display receive test frequency.
(Radio must be in Setup mode.)
Enables Setup mode. Times out after 15 min-
utes. Press "Q" to quit.
) and Baud Rate (
BAUD
ADDR
). In the list below, allowable programming
DESCRIPTION
). However, proper use of
) to view the currently
35