Microwave Data Systems MDS 9810 Installation And Operation Manual page 26

18 MDS 9810 Installation and Operation Guide
The three essential settings for the transceiver are:
Mode—Master or Remote
Network Address—a unique number from 1–65000
Data Interface Parameters—bps, data bits, parity, stop bits
a. Connect an HHT to the
Figure 15). After the HHT beeps, press
ready ">" prompt.
b. Set the Mode—Determine whether the transceiver will be used
as a master or remote, and program it accordingly using the
or
MODE M MODE R
= Remote.) Press
MODE R
.
GRAMMED OK
NOTE: Transceivers are normally shipped from the factory
pre-configured as remotes. A master must be specifically
programmed using the
Figure 15. HHT Connected to Transceiver
c. Program the network address—Type
by ,
SPACE SHIFT
( ). Press
1–65000
programmed with the same network address. After programming
the address,
PROGRAMMED OK
NOTE: It is strongly recommended that the last four digits of the
master radio's serial number be used as the network address.
In this way, it is unlikely that two systems will have the same
address.
DIAG(NOSTICS)
command (Page 41). (
. The HHT will display
ENTER
command.
MODE M
Invisible place holder
ADDR
, and then the desired address number
. All radios in a given system must be
ENTER
will be displayed.
connector (see
to display the
ENTER
= Master,
MODE M
PRO-
(Page 36) followed
MDS 05-3301A01, Rev. C