Installing A Bnc Connector; Procedure - Agilent Technologies 85103E Installation Manual

Installing a BNC Connector

Use the following procedure to install a BNC connector on the rear panel of the 85102.
WARNING
The following procedure presents a danger to your eyes; the law
requires that you use safety glasses during such procedures.

Procedure

1. Put on safety glasses.
2. Turn off line power to the 85102, remove all external cables, and move the instrument
to a clear part of the work area.
3. Remove the lock feet (shown in
4. Position the rear alignment guide (shown in
the BNC connector. Mark the location with a pencil.
Figure 3 85102 Rear Panel BNC Hole Location
85103E Performance Upgrade Installation Manual
Figure 3) and the top cover.
Figure 3) to locate the center of the hole for
85103E Upgrade Package (8510A to 8510C)
Installing a BNC Connector
13