Jamming Detection - Queclink GL300 Manual

GL300 @Tracker Air Interface Protocol
"gl300".

<max download retry>: specifies the maximum time of retrying to download the configuration
file upon downloading failure.

<download timeout>: specifies the expiration timeout of one single downloading. If the
downloading expires, it is considered to be failure.

<download protocol>: the protocol used to download the file. Only HTTP is supported now.
Set to 0.

<report enable>: A numeric to indicate whether to report the message +RESP:GTUPC to
indicate the configuration was updated over the air.
 0: Do not report the message +RESP:GTUPC
 1: Report the message +RESP:GTUPC

<update interval>: The time interval in hour for updating the configuration over the air.

<download URL>: specifies the URL to download the configuration file. If the URL is end
with "/" which means this is just a path without any file, the unit will add <imei>.ini as the
default configuration file name at the end of URL.
The acknowledgement message of AT+GTUPC command:

+ACK:GTUPC
Example:
+ACK:GTUPC, 1A0102,135790246811220,,0005,20100310172830,11F0$
Parameter
Protocol version
Unique ID
Device name
Serial number
Send time
Count number
Tail character
Notice:
1> If the <download URL> is end with "/" which means the URL is just a path
without file name, the unit will add <imie>.ini as the file name to complete the
URL.If it is larger than 100 will be returned error.

3.2.24. Jamming Detection

The command AT+GTJDC is used to configure the parameter for jamming detection. When the
detection condition is matched, then according to <Mode> parameter, the device will report
+RESP:GTJDR or +RESP:GTJDS event message to the backend server.
TRACGL300AN001
Length (byte) Range/Format
6 XX0000 – XXFFFF,
X∈{'A'-'Z','0'-'9'}
15 IMEI
20
4 0000 – FFFF
14 YYYYMMDDHHMMSS
4 0000 – FFFF
1 $
Default
$
- 49 -