Related Manuals for Queclink GL300M Series
Summary of Contents for Queclink GL300M Series
- Page 1 GL300M Series User Manual Cat-M1/Cat-NB1/LTE/GNSS Tracker QSZTRACGL300MUM0001 Version: 1.00...
- Page 2 QSZTRACGL300MAUM0001 General Notes Queclink offers this information as a service to its customers, to support application and engineering efforts that use the products designed by Queclink. The information provided is based upon requirements specifically provided to Queclink by the customers. Queclink has not undertaken any independent search for additional relevant information, including any information that may be in the customer’s possession.
-
Page 3: Table Of Contents
GL300M Series User Manual Contents Contents ............................2 0. Revision History ..........................3 1. Introduction ..........................4 2. Product Overview .......................... 5 2.1. GL300W Series Products ....................5 2.2. Appearance ........................5 2.3. Button / Mini USB Interface Description ................5 2.4. -
Page 4: Revision History
GL300M Series User Manual 0. Revision History Version Date Author Description of Change 1.00 2017.12.16 Kevin Xiang Initial QSZTRACGL300MUM0001 - 3 -... -
Page 5: Introduction
GL300M Series User Manual 1. Introduction The GL300M Series is water resistant GPS trackers designed for lone worker, vehicle, pet and asset tracking applications. The thumb sized button makes the series ideal for applications requiring rapid emergency alert or setting of geo-fences based on current locations. The built-in GPS receiver has superior sensitivity and fast initial positioning. -
Page 6: Product Overview
Button/Mini USB Interface Description Power Key Turn on GL300M Series Turn off GL300M Series when it is not being charged (if the power key is enabled). Function Key Geo-Fence mode Long press the key to enable/disable Geo-Fence ID0. -
Page 7: Led Description
GL300M Series. Backend server developer or administrator can use the Data_Cable_M to configure GL300M Series. 2.4. LED Description There are three LEDs on GL300M Series. For details, please see the table below. Event State CELL LED Fast flash Searching for network The device has been registered to network. -
Page 8: External Power Interface
2.5.1. External DC Charger Interface Pin 2 on the Mini-USB connector is used for charging and named as VCHG pin. It can be connected to a 5V DC power supply to power up GL300M Series and charge the internal battery. 2.5.2. External Battery Interface Pin 8 on the Mini-USB connector is for external battery and named as EXTBAT pin. -
Page 9: Ignition Detection
GL300M Series User Manual 2.6. Ignition Detection Pin 7 on the Mini-USB connector is for ignition detection when GL300M Series is used in vehicle tracking application. It is named as IGN_IND pin. Another easy way is to connect PIN7 to a power output which is only enabled when the vehicle is ignition on (e.g. -
Page 10: Getting Started
During charging, the PWR LED flashes fast. When the battery is fully charged, the PWR LED will be always on. You can also charge the battery via USB cable which connects GL300M Series to the PC. Charging time is about 5 hours. -
Page 11: Gl300W Series External Cable Interface
GL300M Series User Manual 3.3. GL300M Series External Cable Interface GL300M Series External Cable has a Mini USB connector with six wires which allows the connection to the external power interface, ignition detection interface and input interface for GL300M Series. Please find the details in the following table. -
Page 12: Troubleshooting And Safety Info
Do not put the device in the overheated or too humid place, and avoid exposure to direct sunlight. Too high temperature will damage the device or even cause battery explosion. Do not use GL300M Series on the airplane or near medical equipment. QSZTRACGL300MUM0001 - 11 -...